Im trying to connect a PWM pro charge controller to Venus OS, but Venus OS does not see it.
I have a RPI running Venus OS large. It happily runs an MPPT , inverter and 2x BMS.
Im now trying to connect a PWM pro charge controller which runs a second solar and 12v Pb in the same remote location. I have the victron cable RS485 to USB. but it does not show in the device list.
Using SSH to the RPI i can run
$ lsusb i can see the device as: Bus 001 Device 011: ID 04e2:1411 Exar Corp.
The Victron Manual from 2015 talks about installing the drivers using their free Windows program. My problem with this is i dont have any Windows machines only lynux/ubuntu/rpi.
All other documentation relating to the PWM pro just says that it is programmable via Venus OS with no mention of drivers or other.
I have victronconnect and VRM all setup with Venus OS Large on a Raspberry pi.
Any ideas would be gratefully received.
