question

yevgeniy avatar image
yevgeniy asked

Model Phoenix 12/24. When the power switch is turned on, it lights up (bulk) and after a few seconds goes into (failure + fast blinking Bulk) output voltage = 0V

when trying to configure settings:

Adjusting maximum bulk current.

Adjusting absorption voltage.

Adjusting float voltage.

- the system enters setting mode, but the output voltage remains zero


battery chargingchargercharge current limitcharge controller compatibility
1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

klim8skeptic avatar image klim8skeptic ♦ commented ·
Perhaps you could provide a link to you model inverter?
0 Likes 0 ·
0 Answers

Related Resources

VictronConnect VE.Bus charging manual  

Additional resources still need to be added for this topic