question

jakefrpc avatar image

3 Phase Skylla VE BUS Control

Hi Victron enthusiasts, after consulting the manual for the Skylla TG 3 phase I can't seem to find any clear information relating to its ability to connect to the VE BUS and respond to a CAN battery (BYD LVS)'s charge current requirements. As far as I can see they only have an allow to charge yes or no control? We are wanting to use the 3 phase Skylla for charging as we have a 3 phase genset for backup but only require to run single phase loads off of the Multiplus.

Has anyone done this before? Is there a better way to do it?

Thanks!

VE.BusBYDSkylla
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

0 Answers