Hello! My current setup is using a VE.Bus BMS and my MultiPlus Compact 12/2000/80 was configured to that. I remember I had to install an assistant for the VE.Bus BMS. I wonder what I'll need to do now. Should I uninstall the assistant? Do I need to do something at all? Thanks!
Without the VE.Bus BMS you have to delete the VE.Bus BMS assistant.
But you then have to use the "two-signal-BMS" assistant.
6. MultiPlus 500VA – 1600VA & MultiPlus Compact 800VA – 2kVA
Oh that’s super helpful thanks so much!!
Hello! Any idea where I can find more details about the assistant settings? I’m not very sure what I should select. My inverter isn’t responding to the settings I currently have.
Do you have the BMS CL 12-100 to MultiPlus cable (article number ASS070200100)?
The compact Multi don't have a AUX 1 and AUX 2.
You have to connect that special cable to the remote contact like it is described in the link above (no assistant needed) or to the temperature sensor input (assistant needed - one signal for cell high and low)
