My setup is constituted with DIY LiFePo4 battery bank, a SmartShunt, a Cerbo GX, a MultiPlus II and some MPPT. I'm in the middle of setting all this up...
And unfortunately, I have forgotten to wire the battery voltage sense wires and temperature sense cable between the battery and the MultiPlus. A wall is separating the battery and the MultiPlus II, and it's quite cumbersome to have to wire additional cables.
A Ve.Bus cable is wired between the MultiPlus and the Cerbo GX.
Can the Cerbo GX share the battery voltage and Battery temperature reading (both read from SmartShunt, wired in Ve.Direct) with the MultiPlus, so the charger and inverter knows these values and works efficiently?