I am installing the 500 amp Smart Shunt in a new and fixed
location. The distance from the shunt to the battery P + possitive
is only a foot or so. I want to make a clean install and want to shorten
the wire and put on a new ferrule rather than coil up 25' of extra wire.
(I am big time exaggerating the length) How do I remove the ferrule and
red wire out of the shunt? I have seen 100% of people saying where to
insert it ... but nobody shows or tells how to remove it. I have read some
have damaged their unit trying to figure it out. I may just shorten it and put
a snap nut on it and be done... ... Thanks.