- Dear community,
Today i installed a system for a costumer.
Ac input 1 grid 6A
Ac input 2 gen 45A fixed
When the system does start up i see the 6A and i can limit that.
But when the generator runs for a short periode i can see only the 45A that i cannot adjust.
The costumer now cannot adjust the shore power current limiter?
I alreay tried to change ac in 1 and 2.
Is it possible to get the current limiter display fixed on input 1 or 2?
So the costumer can always adjust the shorepower current limiter?
I tried lots of things but could not get it working properly.
With kind regards,
Marc van der Heide
