Hello I just bought a victron deep cycle 110 ah agm to replace the old battery after 3 years. I would like to ask a Victron technician for the correct parameters. I only use a solar charge with a fully configurable 30A mppt regulator. Every day the solar energy is more than enuff to charge completely the battery. I discharge the battery every night on average about 20 ah. I would like to know the correct absorption voltage and the correct duration of the absorption for my use (daily discharge of 20 ah). Currently I have set 14.5v and absorption duration of 120 minutes with temperature compensation of - 4mV / C / cell. Floating 13.7v. Today for example after the end of the absorption, the battery absorbed 0.8A in floating at 13.7V. But trying to increase the floating to 14.5v, I saw that it went up to 2.6A. These is strange for me... Does that mean it wasn't fully charged? Or is it due to gas generation? Then disconnecting the solar panel, after an hour the battery was at 13.5v, so it would appear to be fully charged. The old agm, at the end of absorption, absorbed 0.8a for both 13.7v and 14.5v. Why these difference on new battery? I can see all these parameters on the victronenergy smartshuunt.