House Battery Cable Schematis Diagram XLV.jpgI own a 2000 Prevost Marathon Coach Motorhome. The system uses a proprietary communication system for batteries and cabin management. However, this communication system does not monitor anything but voltage and AMP's through 4 each FEM Current Transducers. . I would like to add a Victron battery monitor to system. There are 6 each 4D Lifeline batteries at 210 AMP's each for house. The existing house batteries are wired in 3 each Series producing 24VDC and 3 each parallel producing 12VDC. Attached is schematic of batteries. I just had to replace under warranty the three 12VDC batteries which Lifeline honored do to bad cell bringing all of them down over time. I need a more robust monitoring system to watch batteries . All I see on dash guage is voltages and amps being used. All I see at Inverter panels is Bulk and Float and charging voltages based on battery temperatures and inverter setup parameters. How do I wire in Victron. The Bus also has a 20K generator onboard.