Low Battery alarm with new firmware (MP2)

Question

question

klaus78 asked Apr 4, '24

After upgrading to the latest firmware I got several low battery alarms.

The voltage seems to be ok (3.12V):

The new ESS assistant is set to LiFePo4 with the default values:

The alarm does not come from the BMS.

What's going wrong here?

Multiplus-II 48v battery alarm

1712214159556.png (29.3 KiB)

1712214209992.png (36.1 KiB)

1712214320562.png (40.6 KiB)

1712214381493.png (34.9 KiB)

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

107 People are following this question.

Answer 1 · 2024-04-04T07:22:19Z

nickdb answered · Apr 04 at 07:22 AM

ESS should not be configured with defaults, they need customising for your battery.

You also need to look at the total battery voltage reported by the multi, not the BMS cell voltages.

It helps to check ccl and dcl as well on the bms.

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Answer 2 · 2024-04-04T07:52:49Z

klaus78 answered · Apr 04 at 07:52 AM

Battery voltage was 51.07V at 23:12.

I will change the cut-off voltages for 0.005C to 50.1V and see what happened.

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.