question

Sigve avatar image

IP67 Bluesmart bluetooth connection

I got a customer who i have sold a 220V BlueSmart IP67 charger to. But I got some problems with connecting to my phone. I cant even put in the six digit PIN.

And when I find the device on the list it just says it needs updating. This is quitting at about 40%. And then I get disconnected.

Furthermore the LEDs on the charger is blinking fast, both the power and mode light. There is not anything about this type of signal in the manual.

Anyone got some tips?

BluetoothBlue Smart Chargerled
10 |3000 characters needed characters left characters exceeded

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
Sigve avatar image
Sigve answered ·

I got it to work. I went back to the customer after a few days and when I got there everything was fine. I got no clue what the problem was.

Share
10 |3000 characters needed characters left characters exceeded

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Guy Stewart (Victron Community Manager) avatar image
Guy Stewart (Victron Community Manager) answered ·

Hi Sigve,

Have you resolved this issue?

Please try connecting with an iPhone. It sounds like the bluetooth interface needs a firmware update.

Share
10 |3000 characters needed characters left characters exceeded

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.