i'm new to Victron but long term smarthome user/DIY developer and know something about modbus. But i didn'nt understand some relationships of setting in my ESS System.
I have 3 Multiplus2, Pylontech Battery and CerboGX running large image.
ESS mode is 1, Optimized mode or 'keep batteries charged' and phase compensation enabled
ESS State = 5, Optimized Mode /w BatteryLife: SoC below dynamic SoC limit
I want to disable discharge battery when my e-car is charged by an go-e Charger.
My idea was to set the related state through MQTT and the Victron Nodes.
But i was not able to figure out which are the right/best settings i have to change.
Is it ok to set just the ESS state to 9 - 'Keep batteries charged' mode is enabled?