I messed with some settings, and added MPII temp sensor to + battery terminal, now Smart Shunt is not displaying its current data on VRM
DC Load - Smart Shunt 500A [274]
2 widgets
Last seen 11 days ago
It is still connected as the ESII is working on bat power only.
Is there reset button/function for SS?
Even in Remote console i can see that it sends data for V, but amps stay at 0, even there is some consumption (-1,7A)
BT Blue light blinks as normal.
If you remove the small red wire that goes to the VBatt+ terminal for a few seconds and then reconnect it, that would reset it. You would lose track of your SOC though, so that would need to be re-synchronised when the battery is known to be full.
Otherwise check that the VE.Direct cable is properly connected at each end. It could have got disturbed without your knowledge when you were doing your other works.
Checked wiring, was ok. Settings>"Current threshold" was automagically changed to 1A, so with base discharge of multiplusii (0.7A) it was not sending any data to VRM.
Settings are quite "fluid" in Victron products, kinda like electricity.
