In my new build single phase system content 6x Q-cell PVarray on a MPPT250 I60 with 3 moduls Pylontech 2000 attached to a Multiplus-II 48/5000/70-50 with Color control GX at my lan-network .
At the display the Pylontech system does not show up in the device list.
There is an VE.direct connection to the Mppt and the original cable between Pylontech an the GX-control. side akku at akku ;
Busresistors installed .
I dont no what tu do please help Iam new in this things with victron
Did you use the original cable that comes supplied with the Pylontech batteries long cable set? If yes, then that is not the correct cable to use.
Which exact model of Pylontech do you have? Example, US2000 should use Type B cable, US2000C is type A cable.
Please make sure you are using the correct cable between master battery CAN port and Colour Control VE.Can port. The cable must also be the correct orientation end to end.
Details about cables here:
https://www.victronenergy.com/live/battery_compatibility:can-bus_bms-cable
There is some setup to do in order to connect the batteries correctly. If you did not study the documentation to do this then then please read and understand the procedure set out here:
https://www.victronenergy.com/live/battery_compatibility:pylontech_phantom
Hello
Thanks for the quick response ; I use the cable typ b that
was not the problem.
My mistake , I pluged the inter battery conections in the same row
as the CAN-Port .
got the connections in the right place " linkport " and everything starts
working as it should !!!
stupid handling took me some houres searching .
The question from me can be closed .
Very important " read and understand " :
https://www.victronenergy.com/live/battery_compatibility:pylontech_phantom
as You pointed out !!!
Iam german and not so good in english it took some time .
Best regards Udo
