Which preset profile should I use for a 12V 22AH AGM Deep Cycle Battery

Question

question

averhaeghe asked Oct 9, '20

Which preset profile should I use for a 12V 22AH AGM Deep Cycle Battery

Hello,

I am using a BAT212200084 reference which is a 12V 22AH AGM Deep Cycle Battery.

My charge controller is a MPPT 75/10.

I would use a preset profile in VictronConnect but I am not sure which one I could use.

I saw "AGM Spiral Cell" profile with : Absorption voltage at 14,7V, Float Voltage at 13,8V and Equalize voltage at 16,5V.

Would it be ok with this profile ?

Thanks

Best Regards

MPPT Controllers VictronConnect AGM Battery

1

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Marnix Keesmaat commented · Oct 10, 2020 at 10:26 PM

I find it still strange that the own brand batteries from Victron are not in the settings of the Victron charge controller, as same brand you would expect it.

I use a Victron AGM Super Cycle (BAT412112081) but there is no AGM Super Cycle battery profile / preset.

https://www.victronenergy.nl/upload/documents/Datasheet-AGM-Super-Cycle-battery-EN.pdf

So I also set it to profile: Gel Victron deep discharge (2).
Because looking at the expert settings of the profile it matched the datasheet.

0 ·

Modifications Space

Node Red Space

Answer 1 · 2020-10-09T16:24:47Z

wkirby answered · Oct 09, 2020 at 04:24 PM

A better preset to use would be "Gel Victron deep discharge(2)".

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

question