I have a MultiPlus 24/3000 (Firmware 469), using a Digital Multi Control to remotely limit the current.
In the past I had no problem switching currents between 5-16 amps. Now however the current limiter is only allowing a maximum of 5 amps. I have tried changing the settings on Shore limit. Turning off "Overruled by remote" does display Ac 1 on the DMC, and does allow me settings over 5 amps. Any settings I try with "Overruled by remote" enabled does limit me to 5 amps, both in "Charger only" and "On" mode.
What could be the cause of this?
