Normally I want a main switch after the first busbar on the positive side. What is the recommended solution for a "complete" Lynx setup?
I'm using two batteries in parallel and will connect them to a Lynx Distributor (each with a 200A fuse).
Normally I want a main switch after the first busbar on the positive side. What is the recommended solution for a "complete" Lynx setup?
I'm using two batteries in parallel and will connect them to a Lynx Distributor (each with a 200A fuse).
12 People are following this question.
Lynx Shunt VE.Can installation
hey all, cant get ve bus to appear/be detected
LYNX VE.CAN-Shunt: Location of the configurable onboard relay
Will the Fuse LEDs on Lynx Distributor illuminate without the 4-pin cable supplied with unit?
Lynx Shunt VE.CAN Battery Status PGN for Batt Instance 0 not transmitted.