I might need to use some ve.can gear soon and I'll need terminators, but I really can't find them anywhere (USA). Does anyone know what the terminators consist of so that maybe I can just make my own?
There are good answers here for the DIY route.
They come supplied with every GX device, and many systems do not use VE.Can functionality, so dealers tend to end up with a few.
It is also possible to purchase them under Victron part number - ASS030700000
I would make polite enquiries with Victron Dealers in your area, they might have some spares.
2x 120 Ohm between CAN-H and CAN-L on both bus ends
Beware there must be no more than 2 (two) terminators in the whole CAN network, one on each network endpoint.
The network (bus) without powered devices should measure about 60Ohm between CAN-H and CAN-L
Additional resources still need to be added for this topic
17 People are following this question.