question

Lars H avatar image

Skylla IP44 in power supply mode.

We are running a Skylla IP44 in power supply mode. On the load side we have a battery and an electronic device. The battery is protected by a breaker and when this is switched off we experience a voltage drop on the output, resulting the connected load to switch off. I my head the output voltage should stay steady in Power supply mode. Any settings to change or is this how it Works?

skylla-i
10 |3000 characters needed characters left characters exceeded

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
Lars H avatar image
Lars H answered ·

Yes we actually did. The information provided by the customer was not correct. It turned out that the voltage increased when the breaker was swithced off, alternating between 32 - 34V and causing the load to switch off. The voltage sense was Connected on the batteries so when the breaker was switch off the voltage Reading was below nominal causing the Skylla to increase the voltage .

Share
10 |3000 characters needed characters left characters exceeded

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Daniël Boekel (Victron Energy Staff) avatar image
Daniël Boekel (Victron Energy Staff) answered ·

Hi @Lars H

Did you find the cause of the voltage drop? to what voltage did it drop?

Share
10 |3000 characters needed characters left characters exceeded

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.