EasySolar 24/3000/70-50--MPPT150/70 exiting absorption stage too early

Question

question

mobi asked Jan 31, '19

1] EasySolar SAPS w/- 24v/666Ah/c10 batt'. Batt' manufacturer's specs require 3hr absorption

1a]MPPT always exits Absorption stage after 1hr - when set point is 3hrs - regardless of solar pv conditions

2] system energy usage = no daytime load/battery consumption = 2.6hrs nightly/1.80kw load, load disconnected @ 68%soc.

2a] have tried increasing to 60%soc over extend period still only 1hr Absorption

3] MPPT & multi firmware upgrade and battery settings rechecked 21/01/2019

any ideas & or solution??

Cheers

battery charging EasySolar All-in-One

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Answer 1 · 2019-01-31T06:05:28Z

JohnC answered · Jan 31, 2019 at 06:05 AM

Hi Mobi. Your mppt is 'fine tuning' your manufacturer's recommendations. Should it do that? is for you to decide. This is old, but these things don't change much: https://www.victronenergy.com/upload/documents/Adaptive_charging_how_it_works.pdf

You'd need to add kit to your Easy to adjust that (for now). I wouldn't worry myself..

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.