Use of Virtual Switch im Multiplus II Parallel System

Question

question

giampaolo asked Jan 7, '24

I have set the virtual switch in my system with two Multiplus II 48V 5KVA to use the AC in only when batteries are lower tha a certain value.

Settings are as follow:

Accept AC in when batteries are lower than 51.90 volt for 60 seconds;

Do not accept AC in if batteries are higher than 52.20 volt for 120 seconds;

I have also set in VS option do not switch off within 5 minutes from switch on.

Despite my settings I am noticing that the system acts in its own way and continue to go in passthrough every two minutes.

virtual switch

2

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

snoobler commented · Jan 08 at 01:43 AM

Post your VEconfig VS ON and VS OFF screens.

0 ·

giampaolo snoobler commented · Jan 08 at 08:28 AM

Here are the screens of my VS in VE config file.

0 ·

vs1.jpg (78.7 KiB)

vs2.jpg (90.1 KiB)

vs3.jpg (92.6 KiB)

vs4.jpg (84.9 KiB)

Answer 1 · 2024-01-09T09:39:48Z

giampaolo answered · Jan 09 at 09:39 AM

It seemed to me that I posted a reply but there is no trace.