Earlier this week I replaced the PWM controller in my motorhome and I hooked up the SmartSolar 100/20 to the existing controller through the TX port to be able to upload data to my server (traveling stats etc.). Works as expected however I see some ghost data (currently it's dark) on the "I" output being 30 mili amps and in the example pic one is 100 mili amps. As I convert milis to amps it shows a 0.03 (0.10) amps. Just wondering if this is just measured amps or just a wrong reading or rounding and where this is coming from.
Would like to see this value being 0 when there is no charge on the batteries.
Thanks,
Martijn 
