question

bezda avatar image

Smart Battery Protect ignoring load disconnect signal

My smart battery protect seems to be ignoring load disconnect signals. I suspected some short circuit or back current, but even with output disconnected, it's still on when I pull the load disconnect wire. Any ideas what could be wrong here?

Battery Protect
2 comments
2 |3000 characters needed characters left characters exceeded

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Have you tried to connect some load to the output of the BP?

bezda avatar image bezda Matthias Lange - DE ·

I have, still the same problem. It should not even start without the high/low pin(s) active

0 Answers