question

greg-c avatar image
greg-c asked

Float charge mode with no battery connected

Hi,

I have a Multiplus 48|3000|35 with a PowerPlus Eco LFP battery. This battery has its own built-in circuit breaker and internal BMS. The battery BMS provides a NC dry contact when all is well. A BMS alarm of any sort (low/high voltage, fault current, temperature, circuit breaker trip, etc) will open the NC contact.

I am using the Multiplus "Two signal BMS" assistant (single contact for high/low) to control what happens if the battery BMS contact opens. My current (preferred) setting is to "switch to float" rather than "bypass" because I think it would be safe under most conditions. And, if the BMS cable was removed or faulty at least the battery would be on float charge.

My concern is that if the BMS alarm was cause by the battery circuit breaker tripping the Multiplus would be float charging to no battery load. Is there any problem with the Multiplus being in float charge mode with no battery?

Regards, Greg

chargerPowerPlus
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
ben avatar image
ben answered ·

Nope, no problem with that.

2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Related Resources

Chargers.

Additional resources still need to be added for this topic

Additional resources still need to be added for this topic