Is it possible to switch the Quattro state, on/off/charger only, over CANBUS/NMEA? What messages would need to be sent?
I see in the VRegs doc that the code 0x0200 is a read/write command.
Is it possible to switch the Quattro state, on/off/charger only, over CANBUS/NMEA? What messages would need to be sent?
I see in the VRegs doc that the code 0x0200 is a read/write command.
MultiPlus Product page / Quattro Product page
MultiPlus 230V Manual / Quattro 230V Manual
MultiPlus 230V Datasheet / Quattro 230V Datasheet
VE.Bus Error codes / VE.Bus configuration guide
Additional resources still need to be added for this topic
68 People are following this question.