question

l-p avatar image
l-p asked

Using Cerbo GX switch contacts for triggering BP200

Hi All,


I would like to use a dry switch contact on the Cerbo GX ( configured to NC ) to trigger a BP200. The purpose is to do Load shedding for Hi-Amp circuit at SOC setpoint; the Load Disconnect on the VE BMS is being used to trigger another BP200 at a lower SOC to protect the batteries.


LP

cerbo gx
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

0 Answers