When setting up the BMS assistant on multiple Quattros, it asks about the Ve Bus Address of the unit with the BMS connection. How do I find out the Ve Bus address?
When setting up the BMS assistant on multiple Quattros, it asks about the Ve Bus Address of the unit with the BMS connection. How do I find out the Ve Bus address?
I use the one input of the two-signal BMS on lead acid batteries to keep it permanently in float (disabling repeat absorption)
If I set up a multiple-Quattro system, it asks for the address when setting up the first unit. It suggests "1" and I leave it set to "1" and it appears to work; but I just wondered if it should always be "1" (and not "0")
40 People are following this question.