Can I connect 3 VM-3P75CT to a cerbo. I would like to monitor 3 separate 3phase supplies and use the generator start/stop function in the cerbo to start a generator when the total load exceeds a certain level and stop the generator when a drops below a certain level.
Yes, it works well with the CERBO. I'm using the CAN connection directly to CERBO. I have my unit on single phase marked as generator. It takes the CERBO a while to figure out it is there and working. I am having issues with correct measurement of amperage. Working on that when I saw your question. I think you can have three of these units operations, it has the ability to mark a VM number. I'm only guessing from what I have seen from it so far. Good luck.
