Hi everyone. I have installed Venus OS on my RPI (ver.2.80-41). I would like to be able to program the analog inputs to connect the tank level probes but I can't. I looked at several pages on this forum but to no avail. I'm using MCP3208. The problem is that from terminal I can see the values of the connected probes (cat /sys/bus/iio/devices/iio\:device0/in_voltage[0-7]_raw) but I don't see them on the rpi GUI. What am I doing wrong? Ideal would be a step by step guide because I no longer remember all the steps that I have done or have not done. I've been on it for a week!