Hi Folks,
I use Smartsolar controller 75/15 with a mobile solar module which is only connected temporarily to the controller. I like to switch the load output on only when the solar module is connected and off all other time. Is that possible and how can I configure it?
Greetings, Ed
You can set the load output to switch on at set voltages in the user defined settings.
If you set the turn on for example at 13.4v and turn off at 13.1v then it should only turn on when your battery is charging and above the set point.
These numbers would need to be adjusted to suit your battery settings with turn on being just above your float voltage and turn off just below.
