Hi,
We have the following components:
1 x Multiplus 48/5000
1 x 250/100 Victron MPPT charge controller
6 x Canadian Solar 405W Solar Panels
1 x Venus GX Controller
1 x BMV 712 Battery Monitor
4 x 120Ah AGM Batteries
1 x ET112 Energy Meter
We have our setup feed excess power to the Grid. If the grid fails (Which was less than 5 minutes) it works with solar and the batteries to supply energy to the loads. Once the Grid is restored it no longer feeds excess power to the grid. It will just supply from grid to loads after this. The panels are basically ignored. They do give a bit of power, but nothing like before the grid fails. I have to reset the Venus to enable feed back to the grid.
I have the following ESS Settings:
Mode : "Keep Batteries charged"
Inverter AC output in use: ON
Feed-in excess solarcharger power: ON
Limit charger power: OFF
Have I got a missing setting somewhere or is this a bug?
