I know this topic somewhat has been addressed in the forum before, but nevertheless.
My problem is that the Victron MP refuses to accept the power from the gen set. I have tried to configure the MP through the Ve Config , and tried all the various combinations of settings,
The only time it will work, is when I enable "weak ac", but the sad thing about that is that the MP is less efficient. it only charges about 13-1400W, which is significantly lower than its rated charging capacity
If I disable the weak ac setting, the MP starts charging ,and slowly increases the charging to its maximum rated capacity , and then cuts off the charging, then after a while the same thing happens again.
Since the generator is able to provide 5,7 KW continuous power, its not due to power overload
Im currently running
I have noticed that there is a newer FW available .
Any change the new FW would resolve any of this?
Any advice how to improve this?