Good day all.
I've been getting the above mentioned warning for a few weeks now. My installation went live 24 November 2022.
Every time the grid fails (loadshedding in South Africa), I get this warning and then it clears. Warning only, no alarm.
My installer installed an over under voltage protection relay after my main incoming breaker.
My grid code was changed as well as AC in low was changed to 210V
Still I get the Overload L1 warning when the grid fail. Not every time, but occasional. Few times a week.
Looks like my system is picking up a very low voltage from the grid just as the grid drops out (saw 61.4V today on the VRM graphs)
No idea how to or where to now from here?
What else can we try or look at?
Would really appreciate if anyone can assist in this matter.
2 x Victron Multiplus II 48/5000
1 x Victron SmartSolar MPPT RS 450/200
2 x Solar MD 14.3kwh batteries
28 x IBC 400W Solar panels
Cerbo GX and Touch 70
2 x Victron Lynx Power In
Regards,