question

hugues avatar image
hugues asked

Can I pull this connector out (Multiplus II)

I want to connect my temperature sensor to my Multiplus II Inverter.

I need to connect both pins to T-sense + and - on picture below.

But the screws are next to impossible to reach.

I suppose we can pull out the green connector from there ? (like on my VE.Bus bluetooth dongle)

I tried but it did not come out right away, just want to be sure and avoid breaking things.

Instruction manual does not say anything, unless I missed it.

img-20231026-172646.jpg

Multiplus-II
img-20231026-172646.jpg (682.8 KiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
Justin Cook avatar image
Justin Cook answered ·

Yes, those connector blocks pull out for ease of installation. There's a little tiny plastic hook on them to make sure they don't fall out accidentally, which is why they give a bit of resistance to being pulled out, but just give it a touch of encouragement.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.