Hello, I watched this video that showed over voltage protection not working on the Victron battery protect.
Is this fault persistent through all of these or just with the device in the video?
https://youtu.be/oQk67t8vVNY?si=YPnC59W4_Z_1qKQo
Cheers
Ben
My suspicion is that since he had no actual load connected for any of that video, but was only measuring voltage, that's the cause of the issue. Without any load connected, I've seen voltage stay high on a BP or SBP, but operation is still fully within spec when a load is connected.
He may have had a faulty unit, but I think it's more likely that the behavior shown in the video was just a result of it not, in fact, being actually installed. Sometimes "test" circumstances don't give us good indication of real-world operation.
