Since adding 2 Victron Smart MPPT's to my configuration, the Multiplus II GX just sits on Bulk. All was working fine before. You can see the SOC is over 20% (which is the floor set in the SMartShunt). Please help to get this working again so it goes into Inverter mode.
Here is a VRM snapshot with an AC load, the Multiplus-II should have switched to Inverter mode, it was OK before I added the 2 MPPT's ?
Could be a few things. Interesting that no current is shown going through the battery. Charge state may be incorrect, any idea when it last synched to 100%?
To start with
Check cabling correct, MPPTs should be connected to the load side of your shunt As should the multiplus.
What happens when AC in disconnected?
Are you using Bluetooth connections/smart network? This mix should, I think, use VE Direct Comms only.
Which GX device are you using?
