What temperature is displayed in left lower corner? See picture below from the linked publication.
When using Node-RED to feed a measured temperature to both a virtual temperature sensor as well as all the available virtual motor temperature sensors, there is still no temperature displayed on the boat page.
Older issues known but agreed not to push for all to hard:
On my boat that is the battery temperature, which is the logical conclusion as all info on the left relates to the battery, SOC, time to go and temperature.
That’s interesting. From what source: BMS, Multiplus, Smartshunt or other?
On our test system battery temperature is measured by the MultiPlus II - GX while uding a BMV-712 as battery monitor. I’ll test what happens with a temperature sensor on the BMV. Still, even if that shows up, I’d rather see the motor temperature because the motor de-rates quite a bit when hot under full power. (While battery temperature is hardly ever an issue and when it is it should set of an alarm)
When I switch the battery monitor setting from the Smartshunt to the MultiPlus the temperature pops up on the boat page indeed. I guess I need to implement a virtual battery if I want to take temperature from another source than the active battery monitor.
Mach ich gerne wenn die Version mit virtuellen Switches freigegeben ist, dann kann ich die node-red controls entfernen . Aktuell gibts keine 3.70 beta. Sonnige Grüße
Yes, I also noticed this and a new reactive strategy was added in v3.70~ for dess to allow self consumption, but it was in an earlier version than v3.70~24.
I’m a bit confused. Last night I loaded v3.70~24. As noted above, the brief was missing the center battery info and the generator relay was shown in the switch panel.
This morning both items are fixed, without any changes to the firmware, and the relay panel looks completely different than last night.
