Generator
Generator Node
[image]
[image]
Hi
This is in Autostart mode.
When I set up a node to find out why gen starts (Condition that startet the gen), I only get to report the number 1, manual.
Does anyone else use this for something, get a different status?
In the picture it started on SOC but it does not come up.
update:I see it at first, but then it disappears very quickly.
update2: Since it is in manual, it looks like it does not stop as it should
(the tank gauge is not connected yet)
With best regards
Per-Marius
https://vrm.victronenergy.com/installation/18889/share/90968aa1
permariusteigen asked
[image]
[image]
HiThis is in Autostart mode.
When I set up a node to find out why gen starts (Condition that startet the gen), I only get to report the number 1, manual.
Does anyone else use this for something, get a different status?
In the picture it started on SOC but it does not come up.
update:I see it at first, but then it disappears very quickly.
update2: Since it is in manual, it looks like it does not stop as it should
(the tank gauge is not connected yet)
With best regards
Per-Marius
https://vrm.victronenergy.com/installation/18889/share/90968aa1
permariusteigen answered ·
1 Answer
Node Red Time Zone And Such...
I realize this is a couple of related questions, but here goes:
Is that any way to read the timezone offset that the user sets in the Venus GUI into NodeRed? I am trying to make decisions based on local time, which since I am a sailboat, that changes and changing it when it is hard coded into NodeRed is a bit awkward... I do have access to the GPS position that is on the CANbus, and could calculate a "solar time" based on latitude, but that seems clunky...
The vaguely related question: Is there any way to access the user set value for the "Quiet Hours" used by the generator autorun function?
Even further afield from the original question: Are the other parameters set by the user and used by the generator autorun function accessible to NodeRed?
I haven't found any of these on the published Modbus register listings.
billknny asked
I realize this is a couple of related questions, but here goes:
Is that any way to read the timezone offset that the user sets in the Venus GUI into NodeRed? I am trying to make decisions based on local time, which since I am a sailboat, that changes and changing it when it is hard coded into NodeRed is a bit awkward... I do have access to the GPS position that is on the CANbus, and could calculate a "solar time" based on latitude, but that seems clunky...
The vaguely related question: Is there any way to access the user set value for the "Quiet Hours" used by the generator autorun function?
Even further afield from the original question: Are the other parameters set by the user and used by the generator autorun function accessible to NodeRed?
I haven't found any of these on the published Modbus register listings.
0 Answers
