So, per the installer of the original system, the configuration includes parameters that will pull power from the grid of the batteries fall below a particular level. Can someone please point me to where in the configurations this might be coded? Thanks.

In the GX Device follow the GX flow to get to it [IMG_6220]

Interesting … no ESS Assistant found… :thinking:

How are you running it? Is it for grid backup peak shaving? If so it should have Ess loaded what device do you have and how is connected

Since a picture is worth a thousand words, here is the installation. On the roof are 30panels divided into 3 groups. While the system is connected to the grid, current settings do not feed into the grid and the grid only produces power should the system be in recycle or the batteries fall below x…

Nice install but is the system running the house/providing backup if so ESS needs to be loaded onto the multiplus if a firmware update has been done on the multi this could have erased the ESS if it was there to begin with, I take it the batteries talk directly to the GX device? If your going to con…

Pull from grid when batters < threshold amount

Q&A and troubleshooting

Daza 30 November 2025 15:49 2

In the GX Device follow the GX flow to get to it

Topic		Replies	Views
ESS fails. Battery to grid fails DIY beginner , ess , 3-phase , cerbo-gx	3	114	19 December 2024
Design Advice for ESS without Solar DIY beginner , ess , domestic , design , multiplus_2_gx , fogstar	20	750	15 August 2025
ESS using battery when grid is available Q&A and troubleshooting beginner , ess , multiplus_2_gx , pylontech	7	263	24 November 2024
ESS setup - self consumption priority but drawing from grid - what am I doing wrong? DIY ess , ekrano_gx , multiplus-ii , cerbo-gx	29	371	15 May 2026
Multiplus II 48/5000 70/50 unable to program ESS Assistant correctly and G98 Export isn't working Q&A and troubleshooting diy , multiplus-ii	12	325	9 October 2025

Pull from grid when batters < threshold amount

Related topics