Can you confirm what versions you are running? Thanks.
?? firmware version shown above.
Wasn’t sure if thats pre or post. Its an old beta. Rather update to ga or the latest beta.
That was post.
Fair enough, then please try reproduce on either 3.72 GA, or 3.80~22. 3.73 is enroute, but that is a very old beta.
It’s an unusual problem, so there must be a cause that is localised.
Hi Nick,
I’ve updated the firmware and powercycled the Cerbo. This time it was ok. So I suspect it must be related to the previous firmware + a specific but unknown local condition of that Cerbo.
- The fault did not occur with firmware prior to that version.
- latest firmware loaded this morning. (3.73~1).
Ok, thanks keep an eye. There have been so many changes since 3.71~2 so it should be fixed by now.
