question

mk1 avatar image
mk1 asked

Grid relay error - everything checked and still cause problem

Hi I have problems with 3 phase instalation with 3 x multiplus II 3000 VA.

On off grid mode everything works fine but when mains is on cause error 11.

Below more details please help to indificate what cause a problem:

alarm-status-grid-relay-error11.jpg


alarm-status-grid-relay-error11-step7.jpg


Multiplus-IIRelayerror 11
3 comments
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

nickdb avatar image nickdb ♦♦ commented ·

Did this work fine before or is this a new installation and it has done this from the start?

These are the documented recommendations:

Other shown error details, listed below, are not related to any known installation issue and can be caused by a faulty unit or configuration issue. In any case, also when one of below errors shows, make sure to go through all the above steps for any error 11 issue.

  • Failing steps #2-7.

  • Communication error.

  • UMains mismatch.

  • Period Time mismatch.

  • Drive of BF relay mismatch.

0 Likes 0 ·
mk1 avatar image mk1 nickdb ♦♦ commented ·
But How Can i fix it ?

PV inverter works fine on this grid on EN505

So multiplus is broken ?

0 Likes 0 ·
Alexandra avatar image Alexandra ♦ mk1 commented ·

@mk1

Follow the steps for troubleshooting in the manual. To determine if your wiring has an issue or not.

The PV inverter working is not a good indicator. Also answering whether this is a new install or not as @nickdb asked would help?

https://www.victronenergy.com/live/ve.bus:ve.bus_error_codes#error_11_-_relay_test_fault_-_installation_error_or_possibly_relay_failure

0 Likes 0 ·
0 Answers

Related Resources