In our sites we have two or more smart solar mppt 150/100 or 250/100, when we can test our batteries we need to shutdown our controllers, ¿Can I connect two or more remote switch control in parallel mode?? or we need a Normal Close relay for each one?
Thanks for your support
Jorge G
There are a few options depending upon your setup.
If you have a two or more MPPT's connected to the same battery bank, then you can use one relay to controll all MPPT's, Connect a relay to battery - terminal and then the other to the L terminal of the remote connector of each MPPT for normal operation.
Or connect a relay from battery + terminal to the H terminal of the remote connector of each MPPT for normal operation.
If MPPT's are connected on different battery banks then use one relay for each MPPT connecting H and L together for normal operation.
Thanks so much, well as you said due have two units connected to the same battery, we connect both in parallel mode. but it dosent work.
could You tellme if there is any diference between remote on/off conector in the unit 250/100 and another remote on/off conector in the 250/100 Vcan???
thanks so much, Jorge G
