VRM shows overall charged energy and NOT the energy of last session for EVCS

Q&A and troubleshooting EVCS
1

The last few weeks the VRM only shows the overall charged energy by the EVCS, since it was installed, and not the energy charged in the last session, like ik was before. I liked it better when it (also) showed the energy used in the last session.

In a system with no backup battery it looks like this in VRM:

image
image1153×276 21.6 KB

In systems with a battery, it looks like this:

image
image1162×730 40.5 KB

The EVCS in a system with a backup battery shows the overall charged energy AND the charged amount of the last session in the tile for the EVCS.

2

Hello @AukedeGr . Thanks for reporting this. Could you please provide a bit more detail about the GX and EVCS firmware versions where you noticed this issue?

3

I’m having same problems. It started when I updated the gs to the latest firmware

4

The Cerbo is on version 3.80~5.

The EVCS is on 2.05.

There is no backup battery in this system. Just the Cerbo, EVCS and grid meter and PV meter, connected to the Cerbo.

5

Thank you, guys. I will get back here after the investigation.