Hello,
Feedback from testing. Venus GX + 2 EM111 energy-meter on 1 USB. (test installation)
1- Wifi symbol is now present !!
Nice to see this status back
What about GPS icon ? (I can’t fix satelite signal from the room of that test system)
and what about the ETH port ?
2 - Grid meter handling (I do not (yet) have a Mltiplus or other, so only Energy meter setted as
1 - Grid (mesuring all Lights of the house)
2 - Gennerator (Mesuring power-plugs) - Unless the generator is in running state and mesuring some power, there is no bullets shown
Either on Brief view the Generator is not present !
Or this in not programmed to be displayed at the same time ?
And If I list the devices, it show the generator not connected !
Same device details
And in the VRM (Before the update were shown, Generator, Grid and AC Load. Now only the Generator and AC Loads no more Grid …
But If I invert the input AC sources I now can see the grid but no more the generator…
Thank you for your job and awaiting comment/question if needed !
Xavier.