Dear group members,
I have three Phoenix Smart Inverter 48/5000 units, and I’d like to configure them to operate on a single phase — meaning they should work in parallel.
As far as I know, there is no official solution for this, but I’ve read in several places that it’s possible to run these inverters in parallel.
Could someone please explain how this can be done?
They are connected to the display via VE.Direct cables.
@kis.devald See below. Otherwise it would only be possible with VE.Bus inverters. The posts suggesting it is possible, don’t they offers the solution?
Time to trade up to a Multiplus.
Unfortunately, these 3 inverters are already set/given, so they cannot be replaced/changed. I am aware that officially it’s not allowed, but I’ve seen it done before, which is why I’m curious about how they do it.