How long does it take a Victron IP22 12/30 to register an amp charge?

DIY
, ,
1

Hello Everyone,

I have a pair of 100ah Lithium Batteries, first time charged at 135ah?.

IMG_7634
IMG_76343024×4032 2.87 MB

I am trying charge again. Battery status 1@12.16v & 1@12.21v. These are connected in series in my Power-chair when in use.

I have contacted them as two, 1x30a cable from charger connected into a split feed cable as previously done. No ah being displayed on phone app.

I then did the same but with one cable one battery. Still no ah charge shown.

Any advice or suggestions, would be greatly appreciated.

Regards
James

IMG_7689
IMG_76891170×2532 271 KB

IMG_7688
IMG_76883024×4032 3.4 MB

IMG_7687
IMG_76873024×4032 3.05 MB

2

At 30A it should be 1Ah every 2 minutes.

But your picture is showing start/end voltage 14.2, i.e. battery is full, no charge…

Probably not connected ?

3

Hi Ludo,

I thought that might have been the problem, but I did a voltage reading(photos) and looks like they are possibly too low?

This was my first charge:

IMG_7634
IMG_76343024×4032 2.87 MB

I will have to contact suppliers and see what I could do?

Many thanks for your help

Regards
James