I am first-time commissioning a Victron system: NG batteries, Lynx BMS, Multi 12/3000, Cerbo GX. I managed to start up the system, load new firmware, control through VRM. I would now like to set the parameters as proposed in manual (of NG batteries): 5.2.1. Charging the battery and recommended char…

maybe take a look … [image] No Battery Tag On VictronConnect And Smart BMS NG/Lithium NG Batteries Q&A and troubleshooting I have 3 x 300ah Lithium NG batteries connected to a Lynx Distributor 1000 and a Smart BMS 1000 NG. The Battery tab does not show on VictronConnect/L…

As you have the Lynx BMS, these settings are preconfigured in the Lynx BMS and you do not need to set them up. The Lynx control charging via DVCC through the GX device. The Lynx BMS manual Section 4.3 lists what can be changed. What you should do anyway is go into any other chargers such as MPPT, …

very good reference. Thank you. For my case though: I do run an NG BMS, with the NG batteries.

The Lynx BMS does it all - very good. Good advice, to still set all charging devices (Multis, MPPTs, DC2DC) with the appropriate Li-settings.

Charger settings: e.g. absorption voltage

Q&A and troubleshooting

Netrange (Steffen) 12 January 2025 19:27 2

maybe take a look …

Topic		Replies	Views
MultiPlus II Charger Settings for Lithium NG Batteries Q&A and troubleshooting marine , beginner , lithium_battery , victron_community	7	527	6 May 2025
Can a non Victron charger be connected to a Victron Lynx NG 500 BMS DIY diy , rv , bms , lynx-ng	1	54	23 March 2026
Where to find correct NG battery settings? DIY diy , lithium_battery	1	141	3 September 2025
Charger for Lynx BSM NG on the Boat Q&A and troubleshooting marine , beginner , lynx_bms	5	123	29 October 2025
No Battery Tag On VictronConnect And Smart BMS NG/Lithium NG Batteries Q&A and troubleshooting marine , victronconnect , diy , lynx_bms , bms	10	328	27 December 2024

Charger settings: e.g. absorption voltage

Related topics