VRM shows a far too high consumption after adding a shelly for heatpump

[aaxc]

Since I added a Shelly to measure heatpump consumption the data in the consumption overview shows far to high values.

VenusOS 3.80-22
VRM Public link: VRM Portal - Victron Energy

Additional information:
The Shelly EM50 has been in use for about a year now.

[aaxc]

Updated to 3.80-27 and it still shows the wrong data.

[agin]

Did you already read here:

AC-Load spikes in VRM

I was happy to read about that fix in V3.80~22. But since install, some spikes in VRM for ‘AC-Loads’ go even higher (>15.000 kWh in one hour) and there seem to be more of them. Today already 3 of them. These spikes are only visible in the System Overview Graph on VRM, nowhere else. I have indeed several FINDER meters attached via Modbus via Virtual AC-Loads in Node-Red on OS-Large. But i’m not aware on how you include their values into the AC-Load graph in VRM. In fact, i would really lik…

and here:

Loads-sehr hohe unrealistische peaks beim Verbrauch

Hi, ich habe in letzter Zeit immer wieder sehr hohe unrealistische peaks beim Verbrauch (ca.2500kWh) für sehr kurze Zeit. Hat einer eine Idee, woher das kommen könnte? Setting: 3x MP2 5000/70, 2x MPPT 450/200, Cerbo, EM 24 Netz, EM 540 für PV mit 2x Hoymiles HMS1600W am am MP Out 1 Liebe Grüße Matthias [image]

?