Venus 3.70 released

[BlindFreddy (G)]

V3.7 loaded on RPi5. Drops internet connection, both Eth and WiFi after a minute or so. Driver issue? Thanks for the progress

[UnixWizard]

What is the new column with tank sensors on the devices page? It’s 0.0 on everything I have configured. Not sure where it’s pulling the number from.

[BlindFreddy (G)]

Further to my last, flashed new card with the large image 2nd on list and all working ok. Supposedly identical to 1st on list other than title?

[jschonen (Jacques)]

I have an issue with my Enphase Metered Gateway. It reports “Production Limit incompatible with Metering Mode” right after upgrading to Venus 3.70 last Friday February 27.. The Gateway reports status “error”.

I had no issues, until I noticed that this morning there was no power from the solar panels while the sun was shining and the sky was crystal clear. I managed to get the solar panels producing by resetting the Cerbo a few times and rebooting the Enphase Gateway.

Interestingly enough the VRM portal did not show any solar production, while the GUI did show the correct info for solar production (see screenshot).

[jschonen (Jacques)]

This morning same issue again. Power Limit stops solar production. Disabling the Power Limit helps for a few minutes, solar starts producing, but then again, solar production stops. Why does the disabling of the Power Limit not work ?

Here is the logging from Enphase:

Restarting Cerbo did not resolve the issue with Power Limit enabled. Restarting Cerbo with Power Limit disabled does bring solar production back up again.

Other strange thing: solar system starts producing at sunrise even when Power Limit is set to zero.

[rz7k9l]

Hi,

on my site the shelly energy meter shows up in devices.

[Kladz]

Any idea why I no longer have solar production on this page since the 3.70 update?

[jcgardner (Jeff Gardner)]

All,

Running Venus Large OS here. As of March 2, the “New UI” began hanging with a complaint of “device not connected to VRM”. The “Classic UI” remains functional. I upgraded to 3.70 Venus Large (and even reimaged to 3.70 Large) and have continued to experience the same issue.

The NON Large 3.70 (standard Venus OS) does not exhibit this bug and works as expected. Any others having a similar difficulty? Any Victron sages working on a patch?

Thanks for the assistance.

Jeff

[nickdb (Nick)]

Any mods, third party drivers, devices etc attached?

[jcgardner (Jeff Gardner)]

Nick,

No modifications, or third party drivers. Just a stock install of the Venus Large OS. It worked perfectly, until it didn’t on Monday.

Thanks,

Jeff

[Kladz]

Hello,

Am I the only one having this issue ?