I absolutely love the new UI, the continued improvements to the entire victron ecosystem is just the icing on the cake to the products.
Can I recommend one change, if the units are set to AMPS, the AC output is shown in AMPS as set.
However as this value is obviously different to the DC side it can cause confusion to some users. Can it also show the wattage at the same time.
Also on the solar input side can we have the UI showing the total DC output current to the DC bus in Amps.
Like below
This could be done with a simple calculation in the system if the value is not already available somewhere else in the code.
For instance in my example above there is an AC coupled PV inverter, so it has no DC output value, but it can be calculated obviously.
Total solar yield/battery voltage
Same with the AC load
Ac output current*AC voltage